Loading product information...
ZENER: বাংলাদেশের সেরা সোলার ও ইলেকট্রনিক্স শপ | WhatsApp: +8801570281650
Loading product information...
-25% Sale5.12kWh LiFePO4 storage delivering 100A continuous discharge with IP66 weatherproofing and 6,000+ cycle life for reliable home backup.
The Solis IntelliHome-5kWh-OD is a low-voltage (51.2V) lithium iron phosphate (LiFePO4) energy storage system engineered for residential solar setups, critical commercial circuits, and demanding backup installations. Designed specifically to eliminate indoor floor congestion, it integrates a factory-sealed IP66 monocoque chassis that permits direct outdoor wall mounting. In areas prone to persistent grid failures, high humidity, and monsoon downpours, typical indoor rack batteries require separate climate-controlled rooms; the IntelliHome-5kWh-OD resolves this bottleneck by operating outdoors down to -20°C and up to +55°C while maintaining complete internal seal integrity. Operating on a 16S prismatic cell architecture, this battery module delivers 5.12kWh of nominal storage with an expansive 44.8V to 57.6V operational window. An industrial-grade Battery Management System (BMS) controls balancing, current draw, and thermal regulation. With 100A sustained discharge capability, a single unit powers high-inductance residential loads—such as water pumps, refrigeration compressors, and inverter air conditioners—without voltage sag or nuisance tripping. Key Engineering Advantages - Grade-A LiFePO4 Prismatic Cells: Built with large-capacity prismatic cells certified for over 6,000 charge/discharge cycles at 80% End-of-Life (EOL), delivering over a decade of continuous daily cycling without thermal instability. - IP66 Outdoor Monocoque Chassis: Rated with IP66 dust/water ingress protection and C5M anti-corrosion coating. It withstands driving rain, salt spray, and extreme dust, removing the need for auxiliary equipment housings. - Full 1C Continuous Discharge: Delivers up to 100A continuous discharge current (5.12kW continuous DC power) directly to the inverter, easily handling heavy surge demands from inductive motor loads. - Direct Closed-Loop BMS Communication: Integrates dual CAN 2.0 and RS485 communication circuits for real-time synchronization of State-of-Charge (SOC), voltage curves, and dynamic current thresholds with hybrid inverters. Compatibility & Application The Solis IntelliHome-5kWh-OD is engineered for direct plug-and-play integration with Solis low-voltage storage inverters, including the S5-EH1P, S6-EH1P, and S6-EO1P series. It also pairs reliably with low-voltage (48V/51.2V) third-party hybrid inverters from Deye, Luxpower, Growatt, and Victron Energy using open CAN/RS485 BMS communication. System designers can scale up to 8 units in parallel on a single bank without an external combiner hub, providing up to 40.96kWh of scalable storage capacity. A single unit reliably backs up typical home circuits including lighting, fans, entertainment setups, computers, refrigerators, and 1.5-ton inverter air conditioners.
Zener Authenticity Promise: All sitemarks, models, and technical statistics are registered with the factory and verified in our physical laboratory before sale.
Size your DC conductors to at least 25mm² (4 AWG) for cable runs under 2 meters, and torque terminal connections to 8-10 Nm to prevent high-resistance localized heating during sustained 100A discharge.
Configure the hybrid inverter to closed-loop CAN communication rather than generic lead-acid voltage sensing to allow the battery BMS to dynamically dictate charge current and prevent premature cell degradation.
While the IP66 casing completely withstands rain and dust storms, mount the unit on a shaded wall away from direct afternoon sun to avoid thermal derating when tropical summer ambient temperatures exceed 45°C.
When paralleling multiple units, use busbars with strictly equal cable lengths to each battery terminal; mismatched cable resistances cause uneven current draws and cell drift between parallel packs.
A1: Yes, the battery carries a certified IP66 ingress protection rating and C5M anti-corrosion coating, making it fully sealed against driving rain, dust, and coastal moisture. For peak thermal efficiency and maximum longevity, mount it under a roof overhang or sunshade to avoid thermal derating caused by direct summer sunlight.
A2: A single battery unit supports a continuous 100A discharge (5.12kW DC power output), capable of running a 1.5-ton inverter air conditioner, refrigerator, LED lighting, ceiling fans, and a TV simultaneously for 2.5 to 3.5 hours. If powering only critical baseline loads (lights, fans, router, and refrigerator), runtime extends beyond 10 to 14 hours.
A3: Yes, this battery operates on standard 48V/51.2V low-voltage architecture and supports CAN 2.0 and RS485 communication protocols used by Deye, Luxpower, Growatt, and Victron Energy. Simply set the DIP switches and inverter battery management profile to matching communication protocol parameters.
A4: You can connect up to 8 IntelliHome-5kWh-OD batteries in parallel to reach a total capacity of 40.96kWh without requiring an external control module. Parallel units link directly via RJ45 communication bridge cables and connect through a common DC busbar to the inverter.
A5: The battery delivers at least 6,000 full charge-discharge cycles at 80% retained capacity, providing 10 to 15 years of daily operation under typical conditions. The built-in intelligent BMS protects the internal cells from thermal shock, overcharging, and deep discharge to maintain this cycle rating.
Only signed-in customers can write reviews. Your review will appear on your profile after moderation.
